17 May
2009
17 May
'09
11:38 a.m.
On 13:49 Sat 16 May , Tom Rix wrote:
Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board. The default serial is from the USB connector on left side of the debug board. The USB connector will produce 2 of the 4 UARTS. On your host pick the first enumeration.
The details of the setting of the serial gpmc setup are not available. The values were provided by another party.
The serial port set up is the same with Zoom1. Baud rate 115200, 8 bit data, no parity, 1 stop bit, no flow.
The kernel bootargs are console=ttyS3,115200n8
Signed-off-by: Tom Rix Tom.Rix@windriver.com
ixx Signed-off-by: Tom Rix Tom.Rix@windriver.com
???
Applied to arm/next
Best Regards, J.