haigao g_hai@huawei.com wrote:
=> printenv bootcmd=bootp 1000000; setenv bootargs root=ramfs console=ttyS00,9600
Pls check your environment settings above. Perhaps you should set like this: bootcmd=bootp; setenv bootargs console=ttyS0,9600 root=/dev/nfs rw ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname)::off; bootm
'root=ramfs and console=ttyS00' is quite strange for me.
ethact=i82559#0
My ethact is 'ethact=SCC ETHERNET'.
## Checking Image at 01000000 ...
Image Name: Linux-2.4.24-pre2
Uhmmm, I suspect you use the kernel source in ELDK3.0.
Right?
Booting progress->[0x8 ]## Current stack ends at 0x0FFB1BB8 => set upper l imit to 0x00800000
## cmdline at 0x007FFF00 ... 0x007FFF00
bd address = 0x0FFB1FC8
memstart = 0x00000000
memsize = 0x10000000
flashstart = 0xFF000000
flashsize = 0x00800000
flashoffset = 0x00000000
sramstart = 0x00000000
sramsize = 0x00000000
bootflags = 0x00000001
intfreq = -165.-993 MHz
The value is a little weird to me. Maybe sth wrong on Power-on init circuit. My custom board also had such a fault with CPU freq. and hanged later.
Booting progress->[0xe ]No initrd
I guess you didn't have ramdisk on your target for you didn't set 'ramdisk_addr'. This is also the reason why I suggest you use 'root=/dev/nfs' rather than 'root=/dev/ram' in bootargs.
## Transferring control to Linux (at address 00000000) ...
--Boundary_(ID_MEOpiNTH9mtRQP5BVjrzNw) Content-type: text/html; charset=gb2312 Content-transfer-encoding: 7BIT
Pls never send HTML to this list. Plain text is well accepted. W.D. don't like to see it. :-)
Best regards,
Sam
_________________________________________________________ Do You Yahoo!? 150万曲MP3疯狂搜，带您闯入音乐殿堂 http://music.yisou.com/ 美女明星应有尽有，搜遍美图、艳图和酷图 http://image.yisou.com 1G就是1000兆，雅虎电邮自助扩容！ http://cn.rd.yahoo.com/mail_cn/tag/1g/*http://cn.mail.yahoo.com/event/mail_1...