Hello,
I am looking to enable the Watchdog Timer on my Freescale iMX6 board and I am following the documentation supplied by NXP which states as follows:
--- The following sequence should be performed for WDOG initialization. • PDE bit of Watchdog Miscellaneous Control Register (WDOG_WMCR) should be cleared to disable the power down counter. • WT field of Watchdog Control Register (WDOG_WCR) should be programmed for sufficient timeout value. • WDOG should be enabled by setting WDE bit of Watchdog Control Register (WDOG_WCR) so that the timeout counter loads the WT field value of Watchdog Control Register (WDOG_WCR) and starts counting ---
I've noticed that in /drivers/watchdog/imx_watchdog.c there is no support for the WDOG_WMCR.
Is there another way to initialise and enable the Watchdog Timer on an iMX board? I am new to this and just following the reference manual as supplied by NXP (http://www.nxp.com/assets/documents/data/en/reference-manuals/IMX6SDLRM.pdf)
Any help would be greatly appreciated.
Regards, Brendan