Am Dienstag 29 September 2009 15:55:55 schrieb Dieter Kiermaier:
Hi everybody,
I try to bring up fw_setenv / fw_printenv in linux kernel but first it want to start with u-boot itself. I built most recent u-boot-marvell git source and get a running u-boot with standard openrd configuration. So far so good.
Hm, it looks like there is the whole nand system somewhat broken :( Haven't seen it earlier, but: U-Boot 2009.08-00208-g9ef0569-dirty (Sep 29 2009 - 15:42:42) OpenRD_base
SoC: Kirkwood 88F6281_A0 DRAM: 27535155593740288 MB NAND: 0 MiB *** Warning - bad CRC or NAND, using default environment
In: serial Out: serial Err: serial Net: egiga0 88E1116 Initialized on egiga0
But boot message state that there is no NAND detected! So I assume that is the main cause for the not working saveenv command? Cross checked it with marvell provided u-boot - this one works. So damaged hardware isn't the case.
Please could somebody check it, too?
Many thanks, Dieter
version says: ArtistaNET-III>> version
U-Boot 2009.08-00208-g9ef0569-dirty (Sep 29 2009 - 15:42:42) OpenRD_base
But saveenv will not work as expected. setenv of new parameter will work but after saveenv and reboot the new parameter is lost and u-boot complains about wrong CRC again.
Any help would be very appreciated.
Dieter _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot