No need for per-SoC adjustment for this parameter. It should be determined by the slowest hardware. Currently, no board overrides this CONFIG, so 3.2 sec is large enough. (If not, we can make it even larger.)
Signed-off-by: Masahiro Yamada yamada.masahiro@socionext.com ---
Changes in v2: - Adjust comment block
drivers/mmc/sdhci.c | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-)
diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index d486082..504f2d2 100644 --- a/drivers/mmc/sdhci.c +++ b/drivers/mmc/sdhci.c @@ -121,12 +121,9 @@ static int sdhci_transfer_data(struct sdhci_host *host, struct mmc_data *data, * for card ready state. * Every time when card is busy after timeout then (last) timeout value will be * increased twice but only if it doesn't exceed global defined maximum. - * Each function call will use last timeout value. Max timeout can be redefined - * in board config file. + * Each function call will use last timeout value. */ -#ifndef CONFIG_SDHCI_CMD_MAX_TIMEOUT -#define CONFIG_SDHCI_CMD_MAX_TIMEOUT 3200 -#endif +#define SDHCI_CMD_MAX_TIMEOUT 3200 #define SDHCI_CMD_DEFAULT_TIMEOUT 100 #define SDHCI_READ_STATUS_TIMEOUT 1000
@@ -164,7 +161,7 @@ static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd, while (sdhci_readl(host, SDHCI_PRESENT_STATE) & mask) { if (time >= cmd_timeout) { printf("%s: MMC: %d busy ", __func__, mmc_dev); - if (2 * cmd_timeout <= CONFIG_SDHCI_CMD_MAX_TIMEOUT) { + if (2 * cmd_timeout <= SDHCI_CMD_MAX_TIMEOUT) { cmd_timeout += cmd_timeout; printf("timeout increasing to: %u ms.\n", cmd_timeout);