Subject: [PATCH 0/3] Support SDMA mode on RPI4 target - 32bit
RPI4's SDHCI controller is supported SDMA mode. (Checked on kernel side) But It doesn't use on u-boot side. Then it's too slow about read/write performance. This patchset is supported SDMA mode on RPI4 target(32bit).
- I didn't test on RPI4 64bit.
Read/write time about 8MB file Before
- Read : 1.472 seconds
- Write : 4.690 seconds
After
- Read : 0.359 seconds
- Write : 0.574 seconds
For patch 2/3, I prefer to use printf, not debug. Other than that, For the whole patchset,
Reviewed-by: Peng Fan peng.fan@nxp.com
This patch is based on my RFC's patches.
Jaehoon Chung (3): mmc: sdhci: use phys2bus macro when dma address is accessed mmc: sdhci: not return error when SDMA is not supported configs: rpi_4_32b_defconfig: enable SDHCI_SDMA config
configs/rpi_4_32b_defconfig | 1 + drivers/mmc/sdhci.c | 16 +++++++++------- 2 files changed, 10 insertions(+), 7 deletions(-)
-- 2.25.0