Hi, About debug, Where should I define the macro to enable debug() function definition? Is there a place in makefile or head file?
On 2013/4/26 3:36, Wolfgang Denk wrote:
Dear "du zhenhuan",
In message 202dafde.df1f.13e4197224a.Coremail.dev_du@163.com you wrote:
1, if NAND flash support is enabled, U-boot just print out "NAND : " without size info and then print out text like "machine check ...,", then print out "resetting board ..." So the board keep resetting again and again. Does this have anything to do with NAND FLASH size change or NAND PART types?
It has probably nothing to do with the NAND flash size, but with the NAND chip type, and/or with other changes you did for your port.
2.if NAND flash support is disabled, U-boot just go to Ethernet PHY initialization part and print out that DP83848 is not supported , Where can I put new driver to support it?
PHY support is in drivers/net/phy/
Are you sure generic PHY support does not work for you?
3.How can I watch more ouput infomation during U-boot boot process to debug these problems ?
Define DEBUG for the interesting files?
Attach a JTAG debugger und fire up GDB?
Best regards,
Wolfgang Denk