The imx8mm and imx8mn appear compatible with imx7d-usb flags in the OTG driver. If the dr_mode is defined as host or peripheral, the device appears to operate correctly, however the auto host/peripheral detection results in an error.
Simply adding checks in ehci_usb_phy_mode for 8mm and 8mn in ehci_usb_phy_mode is not enough, because ehci_usb_of_to_plat is run before the clock is enabled which results in a hang.
Enable the USB clock in ehci_usb_of_to_plat and add checks in ehci_usb_phy_mode for 8mm and 8mn to enable auto detection of the OTG mode on i.MX8M Mini and Nano.
Signed-off-by: Adam Ford aford173@gmail.com
diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c index 1bd6147c76..fa0798171b 100644 --- a/drivers/usb/host/ehci-mx6.c +++ b/drivers/usb/host/ehci-mx6.c @@ -543,7 +543,7 @@ static int ehci_usb_phy_mode(struct udevice *dev) plat->init_type = USB_INIT_DEVICE; else plat->init_type = USB_INIT_HOST; - } else if (is_mx7()) { + } else if (is_mx7() || is_imx8mm() || is_imx8mn()) { phy_status = (void __iomem *)(addr + USBNC_PHY_STATUS_OFFSET); val = readl(phy_status); @@ -561,11 +561,30 @@ static int ehci_usb_phy_mode(struct udevice *dev)
static int ehci_usb_of_to_plat(struct udevice *dev) { +#if CONFIG_IS_ENABLED(CLK) + int ret = 0; + struct ehci_mx6_priv_data *priv = dev_get_priv(dev); + + ret = clk_get_by_index(dev, 0, &priv->clk); + if (ret < 0) + return ret; + + ret = clk_enable(&priv->clk); + if (ret) + return ret; +#endif + struct usb_plat *plat = dev_get_plat(dev); enum usb_dr_mode dr_mode;
dr_mode = usb_get_dr_mode(dev_ofnode(dev));
+#if CONFIG_IS_ENABLED(CLK) + ret = clk_disable(&priv->clk); + if (ret) + return ret; +#endif + switch (dr_mode) { case USB_DR_MODE_HOST: plat->init_type = USB_INIT_HOST;