From: Fabio Estevam fabio.estevam@nxp.com
There is no need call setup_display() from SPL code, so move it to board_init(), which executes only in U-Boot proper.
Reported-by: Stefano Babic sbabic@denx.de Signed-off-by: Fabio Estevam fabio.estevam@nxp.com --- board/freescale/mx6sabresd/mx6sabresd.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/board/freescale/mx6sabresd/mx6sabresd.c b/board/freescale/mx6sabresd/mx6sabresd.c index 5b50bc8..f14b759 100644 --- a/board/freescale/mx6sabresd/mx6sabresd.c +++ b/board/freescale/mx6sabresd/mx6sabresd.c @@ -620,9 +620,6 @@ int board_ehci_power(int port, int on) int board_early_init_f(void) { setup_iomux_uart(); -#if defined(CONFIG_VIDEO_IPUV3) - setup_display(); -#endif
return 0; } @@ -639,6 +636,9 @@ int board_init(void) setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c_pad_info1); else setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c_pad_info1); +#if defined(CONFIG_VIDEO_IPUV3) + setup_display(); +#endif #ifdef CONFIG_USB_EHCI_MX6 setup_usb(); #endif