21 Jan
2004
21 Jan
'04
10:01 a.m.
Scott McNutt writes:
Scott> Using u-boot 1.0.1 with PQ2FADS ... we're not seeing SCL Scott> while executing i2c commands. Port D settings are correct, Scott> copper is good.
Scott> Has anyone seen a similar problem? Anyone successful?
It used to work on MPC8260ADS and MPC8266ADS. On PQ2FADS, I2C is connected to nothing so it was not tested. It's expected to be the same as on older boards. I assume you use the expansion connector to add I2C hardware. I'd check first of all that the configuration (S/W and H/W) is the same as on older boards. Specifically, your add-on H/W must take care of I2C bus requirements.
--
========================================================================
Yuli Barcohen | Phone +972-9-765-1788 | Software Project Leader
yuli@arabellasw.com | Fax +972-9-765-7494 | Arabella Software, Israel
========================================================================