On 2/4/21 3:52 PM, Heinrich Schuchardt wrote:
On 2/4/21 9:29 PM, Sean Anderson wrote:
This is almost identical to the imx7 version, except that the register names are different.
Signed-off-by: Sean Anderson sean.anderson@seco.com
Hello Sean,
I tried to understand where this serial number is ending up.
It seems to be used by the bootm command. But shouldn't we use it to define environment variable #serial instead?
Yes. Typically boards will use get_board_serial to set serial#. For example, the warp7 board does
int board_late_init(void) { /* ... snip ... */
#ifdef CONFIG_SERIAL_TAG /* Set serial# standard environment variable based on OTP settings */ get_board_serial(&serialnr); snprintf(serial_string, sizeof(serial_string), "WaRP7-0x%08x%08x", serialnr.low, serialnr.high); env_set("serial#", serial_string); #endif
return 0; }
I would like to do the same on an i.MX6-based board.
--Sean
Best regards
Heinrich
arch/arm/mach-imx/mx6/soc.c | 33 +++++++++++++++++++++++++++++++++ 1 file changed, 33 insertions(+)
diff --git a/arch/arm/mach-imx/mx6/soc.c b/arch/arm/mach-imx/mx6/soc.c index bf6dddfdc9..cb729be46f 100644 --- a/arch/arm/mach-imx/mx6/soc.c +++ b/arch/arm/mach-imx/mx6/soc.c @@ -11,6 +11,7 @@ #include <linux/delay.h> #include <linux/errno.h> #include <asm/io.h> +#include <asm/setup.h> #include <asm/arch/imx-regs.h> #include <asm/arch/clock.h> #include <asm/arch/sys_proto.h> @@ -705,6 +706,38 @@ int arch_misc_init(void) } #endif
+#ifdef CONFIG_SERIAL_TAG +/*
- UNIQUE_ID describes a unique ID based on silicon wafer
- and die X/Y position
- UNIQUE_ID offset 0x410
- 31:0 fuse 0
- FSL-wide unique, encoded LOT ID STD II/SJC CHALLENGE/ Unique ID
- UNIQUE_ID offset 0x420
- 31:24 fuse 1
- The X-coordinate of the die location on the wafer/SJC CHALLENGE/
Unique ID
- 23:16 fuse 1
- The Y-coordinate of the die location on the wafer/SJC CHALLENGE/
Unique ID
- 15:11 fuse 1
- The wafer number of the wafer on which the device was fabricated/SJC
- CHALLENGE/ Unique ID
- 10:0 fuse 1
- FSL-wide unique, encoded LOT ID STD II/SJC CHALLENGE/ Unique ID
- */
+void get_board_serial(struct tag_serialnr *serialnr) +{
- struct ocotp_regs *ocotp = (struct ocotp_regs *)OCOTP_BASE_ADDR;
- struct fuse_bank *bank = &ocotp->bank[0];
- struct fuse_bank0_regs *fuse =
(struct fuse_bank0_regs *)bank->fuse_regs;- serialnr->low = fuse->uid_low;
- serialnr->high = fuse->uid_high;
+} +#endif
- /*
- gpr_init() function is common for boards using MX6S, MX6DL, MX6D,
- MX6Q and MX6QP processors