Remi Lefevre wrote:
Hello,
I ported U-Boot on my custom MPC8270 board. Everything seems to go well but my ARP packets are malformed:
[snip]
[60 bytes on wire] <- correct correct broadcast correct mac addr ARP type ----------------- ------------------ ----------- 00000000 ff ff ff ff ff ff da b0 4e 0f 0a 26 08 06 00 01 | <- correct 00000010 4e 0f 0a 26 08 06 00 01 4e 0f 0a 26 08 06 00 01 | <- malformed 00000020 00 00 00 00 00 00 c0 a8 00 01 00 00 00 00 00 00 | <- correct 00000030 c0 a8 00 01 00 00 00 00 00 00 00 01 | <- malformed 0000003c
The source mac address seems incorrectly and partially duplicated at byte 16. Data is not random, but duplicated or mispositioned.
I saw the following thread: http://lists.denx.de/pipermail/u-boot/2008-January/028159.html
So I checked and double-checked my SDRAM configuration but cannot find anything wrong. I also get the same results in BBI or PBI.
Is this DIMM memory sticks with using SPD configuration or are the SDRAM chips soldered to the board?
This really smells of misconfigured SDRAM where your SDRAM *timing* is wrong. It really looks like your DMA engine is latching the "next" bus cycle while your SDRAM is still presenting the previous data. IOW, your memory is slower than your SDRAM controller is configured for.
Did you verify the SDRAM databook timing vs. what you configured your SDRAM controller to do? Did the hardware engineer that made the board verify your configuration? Did he give you a good configuration? If so, are you sure it is good??? (never trust the hardware weenies ;-)
Did you read and understand http://www.denx.de/wiki/view/DULG/SDRAM ?
If you are sure of the timing, I would suggest you write a simple test application that DMAs from flash to RAM and verifies it, DMAs from RAM to RAM and verifies it, if possible do two simultaneous DMAs from A->B and C->D so that you are exercising the SDRAM pipelining vigorously.
MII monitoring works correctly: => mii dump
This is meaningless for the problem at hand. The problem is the DMA from SDRAM into the ethernet MAC is messed up. You are messed up before the PHY gets in the picture.
[snip]
Anything I could have forgotten to check ?
Best regards, Rémi Lefevre
In real estate the three most important things are "location, location, location." In engineering, they are "timing, timing, timing."
HTH, gvb