Hi Shami,
On Thursday 20 December 2007, shami Allam wrote:
I assigned the ethaddr as 192.168.13.246 and after that i run the command "saveenv " and reset the board.
As Wolfgang already mentioned, this is *not* an ethernet address but an IP address.
I got the following Net: ppc_4xx_eth0. once i get the shell prompt i assign the ipaddr as 192.168.13.241 and after that i run the command "saveenv" and reset the board. Now i tried to ping my Host PC which has the IP address as 192.168.13.240, i am getting the following error.....I am not able to ping the host IP. Can you please show some way to come of this issue..... => ping 192.168.13.240 Trying ppc_4xx_eth0 PHY speed read failed, assuming 10bT PHY duplex read failed, assuming half duplex ENET Speed is 10 Mbps - HALF duplex connection
Did you configure the PHY address correctly? What does "mii info" show? how did you configure the PHY address in your board config file?
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================