Hi Jagan,
On Fri, May 26, 2017 at 2:28 PM, Jagan Teki jagannadh.teki@gmail.com wrote:
OK, please rebase now, forgot to update this series changes.
The pmic command appears in this version, but I see other issues now:
U-Boot SPL 2017.05-00704-g16fa9ec (May 26 2017 - 14:30:16) Trying to boot from MMC1
U-Boot 2017.05-00704-g16fa9ec (May 26 2017 - 14:30:16 -0300)
CPU: Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz) CPU: Automotive temperature grade (-40C to 125C) at 38C Reset cause: POR Model: Freescale i.MX6 Quad SABRE Smart Device Board I2C: ready DRAM: 1 GiB PMIC: PFUZE100 ID=0x10 MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 gpio@020a4000: dir_output: error: gpio GPIO3_19 not reserved gpio@020a4000: set_value: error: gpio GPIO3_19 not reserved gpio@020b4000: dir_output: error: gpio GPIO7_12 not reserved gpio@020b4000: set_value: error: gpio GPIO7_12 not reserved
(These errors are new)
PCI: pcie phy link never came up No panel detected: default to Hannstar-XGA gpio@0209c000: dir_output: error: gpio GPIO1_21 not reserved Display: Hannstar-XGA (1024x768) In: serial Out: serial Err: serial Net: Warning: ethernet@02188000 MAC addresses don't match: Address in ROM is 00:04:9f:02:70:67 Address in environment is 00:04:9f:02:19:a0 eth0: ethernet@02188000 Hit any key to stop autoboot: 0 => dhcp zImage Read MDIO failed... Read MDIO failed... Read MDIO failed... Read MDIO failed... Read MDIO failed... Read MDIO failed... Read MDIO failed...
(Ethernet does not work anymore).