After the conversion to DM the U-Boot binary is called u-boot-dtb.imx, so fix the README file accordingly.
Signed-off-by: Fabio Estevam festevam@gmail.com --- Changes since v1: - Fix all occurrances
board/warp7/README | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/board/warp7/README b/board/warp7/README index 60339da543..579bb2de38 100644 --- a/board/warp7/README +++ b/board/warp7/README @@ -17,7 +17,7 @@ $ make mrproper $ make warp7_config $ make
-This will generate the U-Boot binary called u-boot.imx. +This will generate the U-Boot binary called u-boot-dtb.imx.
Put warp7 board in USB download mode:
@@ -28,11 +28,11 @@ Connect a USB to serial adapter between the host PC and warp7
Connect a USB cable between the OTG warp7 port and the host PC
-Copy u-boot.imx to the imx_usb_loader folder. +Copy u-boot-dtb.imx to the imx_usb_loader folder.
-Load u-boot.imx via USB: +Load u-boot-dtb.imx via USB:
-$ sudo ./imx_usb u-boot.imx +$ sudo ./imx_usb u-boot-dtb.imx
Then U-Boot should start and its messages will appear in the console program.
@@ -46,9 +46,9 @@ Use the default environment variables: Run the DFU command: => dfu 0 mmc 0
-Transfer u-boot.imx that will be flashed into the eMMC: +Transfer u-boot-dtb.imx that will be flashed into the eMMC:
-$ sudo dfu-util -D u-boot.imx -a boot +$ sudo dfu-util -D u-boot-dtb.imx -a boot
Then on the U-Boot prompt the following message should be seen after a successful upgrade: