1 Oct
2013
1 Oct
'13
10:25 p.m.
On Tue, Oct 1, 2013 at 5:21 PM, Benoît Thébaudeau benoit.thebaudeau@advansee.com wrote:
SION is not GPIO-specific, so no. Eric is right: SION may slightly increase the current consumption if it is set for too many pins, so it does not make sense to set it everywhere, and it may be needed for any pin, not just for GPIOs, so setting it either for all GPIOs or for all pins would not make sense. SION should be set only where strictly required. Since SION is a hardware configuration option, let's keep it a software configuration as well, just like in Linux.
Yes, this seems a good aproach.
Regards,
Fabio Estevam