20 May
2008
20 May
'08
8:47 p.m.
In message 17346329.post@talk.nabble.com you wrote:
When I enter the "target remote" command, it ends up in 0x00000000 instead of the reset vector at 0xfffffffc. I have pasted my commands below. Can anyone tell me what I'm missing? I just want to step through a few instructions and verify that the reset vector code jumps to _start (or _start_440 in my case), and then step through _start afterwards.
Probably your BDI config file needs adjusting. Try what you see when you use the telnet interface directly, i. e. where do you end up after a "reset halt" ?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
"...one of the main causes of the fall of the Roman Empire was that,
lacking zero, they had no way to indicate successful termination of
their C programs." - Robert Firth