Hi All, The issue has been resolved. I built the u-boot-nand.bin image from the u-boot cource code obtained from the AMCC site. With this image tftp is working fine,once i set the ethaddr,serverip and ipaddr. Initially i was working with the latest u-boot source code from the denx site.I found out that there was some differences between these two versions.For example the lates u-boot source code does not contain the file /drivers/net/4xx_enet.c while the one from AMCC site contains the same. Thanks.
Regards, Afzal Nadirshah ________________________________________ From: Stefan Roese [sr@denx.de] Sent: Monday, February 16, 2009 2:45 PM To: Afzal Nadirshah Cc: u-boot@lists.denx.de; Wolfgang Denk Subject: Re: [U-Boot] tftp not working
On Monday 16 February 2009, Afzal Nadirshah wrote:
I did as suggested by you. I also set the serverip as well as ipaddr. Now when i do a tftp 100000 u-boot-nand.bin, i get the following :
=> tftp 100000 u-boot-nand.bin Waiting for PHY auto negotiation to complete...... TIMEOUT !
!!!
done ENET Speed is 10 Mbps - HALF duplex connection (EMAC0) Using ppc_4xx_eth0 device TFTP from server 172.22.68.33; our IP address is 172.22.68.36 Filename 'u-boot-nand.bin'. Load address: 0x100000 Loading: *
It hangs at this point
Your board doesn't have a correct ethernet link. Is this really the original Canyonlands board? Is the correct ethernet port connected?
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================