On Wed, 2019-06-12 at 02:05 +0000, Joel Stanley wrote:
On Thu, 6 Jun 2019 at 04:50, Samuel Mendoza-Jonas sam@mendozajonas.com wrote:
Add the handling of NC-SI ethernet frames, and add a check at the start of net_loop() to configure NC-SI before starting other network commands. This also adds an "ncsi" command to manually start NC-SI configuration.
Signed-off-by: Samuel Mendoza-Jonas sam@mendozajonas.com
We need the u-boot net specialists to weigh in, but this looks okay to me. Please clarify the help text for the NCSI command, then add:
Reviewed-by: Joel Stanley joel@jms.id.au
--- a/cmd/Kconfig +++ b/cmd/Kconfig @@ -1296,6 +1296,12 @@ config CMD_LINK_LOCAL help Acquire a network IP address using the link-local protocol
+config CMD_NCSI
bool "ncsi"depends on PHY_NCSIhelpConfigure the attached NIC via NC-SICan we clarify in the text if we need the 'ncsi' command to use any NC-SI attached NIC, or if it's more for ncsi and network debugging?
Can do - the command manually kicks off configuration of the NC-SI topology, but isn't needed in normal use.