On 20/02/2024 06:56, Sumit Garg wrote:
On Fri, 16 Feb 2024 at 02:22, Caleb Connolly caleb.connolly@linaro.org wrote:
Some platforms hard reset when attempting to configure PMIC GPIOs. Add support for quirks specified in match data with a single quirk to skip this configuration. We rely on the GPIO already be configured correctly, which is always the case for volume up (the only current user of these GPIOs).
I can't find a similar quirk in the counterpart Linux driver (drivers/pinctrl/qcom/pinctrl-spmi-gpio.c). Is there anything we are missing in the U-Boot driver?
It's not ideal, it's fine to have it at first but at some point a proper solution should be found.
Neil
-Sumit
Signed-off-by: Caleb Connolly caleb.connolly@linaro.org
drivers/gpio/qcom_pmic_gpio.c | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-)
diff --git a/drivers/gpio/qcom_pmic_gpio.c b/drivers/gpio/qcom_pmic_gpio.c index 2a4fef8d28cb..198cd84bc31e 100644 --- a/drivers/gpio/qcom_pmic_gpio.c +++ b/drivers/gpio/qcom_pmic_gpio.c @@ -64,6 +64,15 @@ #define REG_EN_CTL 0x46 #define REG_EN_CTL_ENABLE (1 << 7)
+/**
- pmic_gpio_match_data - platform specific configuration
- @PMIC_MATCH_READONLY: treat all GPIOs as readonly, don't attempt to configure them
- */
+enum pmic_gpio_quirks {
QCOM_PMIC_QUIRK_READONLY = (1 << 0),+};
- struct qcom_gpio_bank { uint32_t pid; /* Peripheral ID on SPMI bus */ bool lv_mv_type; /* If subtype is GPIO_LV(0x10) or GPIO_MV(0x11) */
@@ -75,7 +84,12 @@ static int qcom_gpio_set_direction(struct udevice *dev, unsigned offset, struct qcom_gpio_bank *priv = dev_get_priv(dev); uint32_t gpio_base = priv->pid + REG_OFFSET(offset); uint32_t reg_ctl_val;
int ret;
ulong quirks = dev_get_driver_data(dev);int ret = 0;/* Some PMICs don't like their GPIOs being configured */if (quirks & QCOM_PMIC_QUIRK_READONLY)return 0; /* Disable the GPIO */ ret = pmic_clrsetbits(dev->parent, gpio_base + REG_EN_CTL,@@ -304,7 +318,7 @@ static int qcom_gpio_of_to_plat(struct udevice *dev) static const struct udevice_id qcom_gpio_ids[] = { { .compatible = "qcom,pm8916-gpio" }, { .compatible = "qcom,pm8994-gpio" }, /* 22 GPIO's */
{ .compatible = "qcom,pm8998-gpio" },
{ .compatible = "qcom,pm8998-gpio", .data = QCOM_PMIC_QUIRK_READONLY }, { .compatible = "qcom,pms405-gpio" }, { }-- 2.43.1