Hi people,
I'm struggling trying to figure how to totally enable all of those nice debug() statements so as to debug a problem in SPL. The CONFIG_LOGLEVEL is set to 7, have also tried to all KCFLAGS=-DDEBUG but apparently it has all no effect for SPL. So I'm asking for advice (and I'd definitely like to not selectively prepend "#define DEBUG" all over the place)
Background: I'm trying to perform direct nand install on an A20 olinuxino board. That is, dismissing messy boot0 and boot1 in nand. Currently, I've succeeded to get a good greeting from u-boot SPL, declaring that it is going to proceed to boot from nand, but then all stops forever:
U-Boot SPL 2019.01-rc2 (Dec 22 2018 - 22:15:16 +0300) CPU: 912000000Hz, AXI/AHB/APB: 3/2/2 DRAM: 1024 MiB Trying to boot from NAND
I'd like to try to find the reason for this and certainly having all those debug messages could help somewhat.
Thank you!
Regards, Nikolai