Am Sun, Feb 21, 2021 at 08:26:24AM -0800 schrieb Ye Li:
Setup USB clock in board codes, and enable the DWC3 XHCI and PHY drivers to make USB3.0 host port working on i.MX8MQ EVK.
Signed-off-by: Ye Li ye.li@nxp.com
The same change works on the MNT Reform 2 as well.
Reviewed-by: Patrick Wildt patrick@blueri.se
board/freescale/imx8mq_evk/imx8mq_evk.c | 4 ++++ configs/imx8mq_evk_defconfig | 9 +++++++++ 2 files changed, 13 insertions(+)
diff --git a/board/freescale/imx8mq_evk/imx8mq_evk.c b/board/freescale/imx8mq_evk/imx8mq_evk.c index 93da67d..e394805 100644 --- a/board/freescale/imx8mq_evk/imx8mq_evk.c +++ b/board/freescale/imx8mq_evk/imx8mq_evk.c @@ -86,6 +86,10 @@ int board_init(void) setup_fec(); #endif
+#if defined(CONFIG_USB_DWC3) || defined(CONFIG_USB_XHCI_DWC3)
- init_usb_clk();
+#endif
- return 0;
}
diff --git a/configs/imx8mq_evk_defconfig b/configs/imx8mq_evk_defconfig index a149c1a..a644862 100644 --- a/configs/imx8mq_evk_defconfig +++ b/configs/imx8mq_evk_defconfig @@ -54,3 +54,12 @@ CONFIG_DM_REGULATOR_GPIO=y CONFIG_DM_RESET=y CONFIG_MXC_UART=y CONFIG_DM_THERMAL=y +CONFIG_CMD_USB=y +CONFIG_USB=y +CONFIG_USB_STORAGE=y +CONFIG_DM_USB=y +CONFIG_USB_XHCI_HCD=y +CONFIG_USB_XHCI_DWC3=y +CONFIG_USB_DWC3=y +CONFIG_PHY=y
+CONFIG_PHY_IMX8MQ_USB=y
2.7.4