On 2/1/24 16:00, Jesse Taube wrote:
Add documentation for imxrt1170-evk.
Signed-off-by: Jesse Taube Mr.Bossman075@gmail.com
doc/board/nxp/imxrt1170-evk.rst | 42 +++++++++++++++++++++++++++++++++ 1 file changed, 42 insertions(+) create mode 100644 doc/board/nxp/imxrt1170-evk.rst
diff --git a/doc/board/nxp/imxrt1170-evk.rst b/doc/board/nxp/imxrt1170-evk.rst new file mode 100644 index 0000000000..4acccdcc93 --- /dev/null +++ b/doc/board/nxp/imxrt1170-evk.rst @@ -0,0 +1,42 @@ +.. SPDX-License-Identifier: GPL-2.0+
+imxrt1170-evk +=============
+How to use U-Boot on NXP i.MXRT1170 EVK +---------------------------------------
+- Build U-Boot for i.MXRT1170 EVK:
+.. code-block:: bash
- $ make mrproper
- $ make imxrt1170-evk_defconfig
- $ make
+This will generate the SPL image called SPL and the u-boot.img.
+- Flash the SPL image into the micro SD card:
+.. code-block:: bash
- $sudo dd if=SPL of=/dev/sdX bs=1k seek=1 conv=notrunc; sync
This location conflicts with GPT partitioning. Does the SoC support an alternative location for the SPL?
Best regards
Heinrich
+- Flash the u-boot.img image into the micro SD card:
+.. code-block:: bash
- $sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128 conv=notrunc; sync
+- Jumper settings::
- SW1: 1 0 1 0
- SW2: 0 0 0 0 0 0 0 0 1 0 0 0
+where 0 means bottom position and 1 means top position (from the +switch label numbers reference).
+- Connect the USB cable between the EVK and the PC for the console.
- The USB console connector is the one close the ethernet connector
+- Insert the micro SD card in the board, power it up and U-Boot messages should come up.