On Tue, 24 Feb 2004, Andy Hawkins wrote:
You have a load address and entry point of 0x0. You can't load and run Linux at 0x0. Try something more sensible like 0x400000.
The image that comes with the board (and boots fine) has the load and entry addresses both set to zero...
Guys, don't confuse the load address of the pImage with the *download address*, ie. the one used for tftp. Your setting of 0/0 for the load address and entry point is correct.
However, from your initial post I gathered that your MV kernel does not have BSP support for your hardware. It is unlikely that a simple adaption of the boot info structure will be sufficient. Check out the relevant files in arch/ppc/{platforms,kernel} as well as the configure options in arch/ppc/config.in and look for things specific for your board.
Regards, Marius