[U-Boot] [PATCH 1/2] net: zynq: Use predefined macros instead of hardcoded value

MII is used by this driver.

Signed-off-by: Michal Simek michal.simek@xilinx.com ---

drivers/net/zynq_gem.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c index 101489c..08056a4 100644 --- a/drivers/net/zynq_gem.c +++ b/drivers/net/zynq_gem.c @@ -338,7 +338,8 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis) phy_detection(dev);

/* interface - look at tsec */ - phydev = phy_connect(priv->bus, priv->phyaddr, dev, 0); + phydev = phy_connect(priv->bus, priv->phyaddr, dev, + PHY_INTERFACE_MODE_MII);

phydev->supported = supported | ADVERTISED_Pause | ADVERTISED_Asym_Pause; -- 1.8.2.3