Re: [U-Boot] [PATCH v4 1/5] net: mvpp2x: fix traffic stuck after PHY start error

On Fri, Aug 16, 2019 at 1:09 AM nhed+uboot@starry.com wrote:

From: Stefan Chulski stefanc@marvell.com

Issue:

• Network stuck if autonegotion fails.

Issue root cause:

• When autonegotiation fails during port open procedure, the packet processor configuration does not finish and open procedure exits with error.
• However, this doesn't prevent u-boot network framework from calling send and receive procedures.
• Using transmit and receive functions of misconfigured packet processor will cause traffic to get stuck.

Fix:

• Continue packet processor configuration even if autonegotiation fails. Only error message is triggered in this case.
• Exit transmit and receive functions if there is no PHY link indication.
• U-boot network framework now calls open procedure again during next transmit initiation.

Signed-off-by: Stefan Chulski stefanc@marvell.com Reviewed-by: Igal Liberman igall@marvell.com Tested-by: Igal Liberman igall@marvell.com

---

drivers/net/mvpp2.c | 27 ++++++++++++++------------- 1 file changed, 14 insertions(+), 13 deletions(-)

diff --git a/drivers/net/mvpp2.c b/drivers/net/mvpp2.c index bd89725e77..f36c8236b1 100644 --- a/drivers/net/mvpp2.c +++ b/drivers/net/mvpp2.c @@ -4494,7 +4494,7 @@ static void mvpp2_stop_dev(struct mvpp2_port *port) gop_port_enable(port, 0); }

-static int mvpp2_phy_connect(struct udevice *dev, struct mvpp2_port *port) +static void mvpp2_phy_connect(struct udevice *dev, struct mvpp2_port *port) { struct phy_device *phy_dev;

@@ -4504,7 +4504,7 @@ static int mvpp2_phy_connect(struct udevice *dev, struct mvpp2_port *port) port->phy_dev = phy_dev; if (!phy_dev) { netdev_err(port->dev, "cannot connect to phy\n");

•                   return -ENODEV;
  

•                   return;
            }
            phy_dev->supported &= PHY_GBIT_FEATURES;
            phy_dev->advertising = phy_dev->supported;
  

@@ -4516,18 +4516,14 @@ static int mvpp2_phy_connect(struct udevice *dev, struct mvpp2_port *port)

            phy_config(phy_dev);
            phy_startup(phy_dev);

•           if (!phy_dev->link) {
  

•           if (!phy_dev->link)
                    printf("%s: No link\n", phy_dev->dev->name);
  

•                   return -1;
  

•           }
  

•           port->init = 1;
  

•           else
  

•                   port->init = 1;
    } else {
            mvpp2_egress_enable(port);
            mvpp2_ingress_enable(port);
    }
  

•   return 0;
  

}

static int mvpp2_open(struct udevice *dev, struct mvpp2_port *port) @@ -4567,10 +4563,7 @@ static int mvpp2_open(struct udevice *dev, struct mvpp2_port *port) }

    if (port->phy_node) {

•           err = mvpp2_phy_connect(dev, port);
  

•           if (err < 0)
  

•                   return err;
  

•           mvpp2_phy_connect(dev, port);
            mvpp2_link_event(port);
    } else {
            mvpp2_egress_enable(port);
  

@@ -5175,6 +5168,10 @@ static int mvpp2_recv(struct udevice *dev, int flags, uchar **packetp) struct mvpp2_rx_queue *rxq; u8 *data;

•   if (port->phy_node)
  

•           if (!port->phy_dev->link)
  

•                   return 0;
  

•   /* Process RX packets */
    rxq = port->rxqs[0];
  
  

@@ -5240,6 +5237,10 @@ static int mvpp2_send(struct udevice *dev, void *packet, int length) int tx_done; int timeout;

•   if (port->phy_node)
  

•           if (!port->phy_dev->link)
  

•                   return 0;
  

•   txq = port->txqs[0];
    aggr_txq = &port->priv->aggr_txqs[smp_processor_id()];
  
  

-- 2.21.0

Reviewed-By: Ramon Fried rfried.dev@gmail.com