On 01/02/17 14:14, Tom Rini wrote:
On Wed, Feb 01, 2017 at 02:01:11PM +0200, Roger Quadros wrote:
On 01/02/17 12:47, Lokesh Vutla wrote:
On Wednesday 01 February 2017 03:12 PM, Roger Quadros wrote:
On 31/01/17 06:17, Lokesh Vutla wrote:
On Monday 30 January 2017 08:45 PM, Roger Quadros wrote:
In stead of defining the board EEPROM address in the board headers let's define them in the board config files and make them configurable by Kconfig.
Signed-off-by: Roger Quadros rogerq@ti.com
arch/arm/Kconfig | 10 ++++++++++ configs/am57xx_evm_defconfig | 2 ++ configs/am57xx_evm_nodt_defconfig | 2 ++ configs/am57xx_hs_evm_defconfig | 2 ++ configs/dra7xx_evm_defconfig | 2 ++ configs/dra7xx_hs_evm_defconfig | 2 ++ include/configs/am57xx_evm.h | 4 ---- include/configs/dra7xx_evm.h | 4 ---- 8 files changed, 20 insertions(+), 8 deletions(-)
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig index c04adfb..19886ad 100644 --- a/arch/arm/Kconfig +++ b/arch/arm/Kconfig @@ -1009,6 +1009,16 @@ config TARGET_THUNDERX_88XX
endchoice
+config EEPROM_BUS_ADDRESS
int "Board EEPROM's I2C bus address"range 0 8default 0+config EEPROM_CHIP_ADDRESS
hex "Board EEPROM's I2C chip address"range 0 0xffdefault 0x50IMO, these should be placed in board/ti/common/Kconfig. Also need not specify the value explicitly in defconfig if default value is used.
"board/ti/common/Kconfig" is not used by keystone Is it OK to source it in board/ti/ks2_evm/Kconfig?
yes. I don't see any problem with that :)
If I do that I get the below error. I think it is because SPL_NAND is being enabled but not required for K2? Are all options in ti/common/Kconfig relevant for K2?
The Kconfig file may need some minor tweaks / dependencies added to be used on keystone, and long term we'll be doing all of those "config SPL_FOO\ndefault y" entries another way. The NAND entry could be changed (but you'll need to test, and shoving a test branch at travis-ci is an easy way to test) to be instead of 'default y' be 'default CMD_NAND' I think.
It starts to look ugly if I add conditions in the Kconfig file. Why are we setting default y to various SPL_* options in this file? Shouldn't the board config file explicitly set the values? e.g. some TI board might not need SPL_I2C and other might need it.