The behavior before this patch would attempt to configure the mux setting for pins 0 to 27 on PORTD to all be setting 3 for LVDS. The LVDS interface actually only uses pins 18 to 27 and not pins 0 to 27 as in the parallel LCD interface. This patch restricts the configuration to only the relevant pins 18 to 27 on PORTD.
This was tested on a sun8i A33 tablet with an LVDS screen. MMC1 has the capability to use pins 2 to 7 on PORTD and the mux on those pins was being inadvertently set to setting 3 for MMC functionality which this patch corrects.
Signed-off-by: Lawrence Yu lyu@micile.com ---
drivers/video/sunxi_display.c | 4 ++++ 1 file changed, 4 insertions(+)
diff --git a/drivers/video/sunxi_display.c b/drivers/video/sunxi_display.c index 9fee66a..3674ae1 100644 --- a/drivers/video/sunxi_display.c +++ b/drivers/video/sunxi_display.c @@ -767,7 +767,11 @@ static void sunxi_lcdc_tcon0_mode_set(const struct ctfb_res_modes *mode, (struct sunxi_lcdc_reg *)SUNXI_LCD0_BASE; int bp, clk_delay, clk_div, clk_double, pin, total, val;
+#ifdef CONFIG_VIDEO_LCD_IF_LVDS + for (pin = SUNXI_GPD(18); pin <= SUNXI_GPD(27); pin++) { +#else for (pin = SUNXI_GPD(0); pin <= SUNXI_GPD(27); pin++) { +#endif #ifdef CONFIG_VIDEO_LCD_IF_PARALLEL sunxi_gpio_set_cfgpin(pin, SUNXI_GPD_LCD0); #endif