Dear Przemyslaw,
On 09/09/2013 09:50 PM, Przemyslaw Marczak wrote:
This change allow to use sd card on Goni the same like mmc 0. SD card is mmc dev 1, so it can be used like this: "fatls mmc 1:2". SD card is inited even if eMMC initialization fails.
Signed-off-by: Przemyslaw Marczak p.marczak@samsung.com Signed-off-by: Kyungmin Park kyungmin.park@samsung.com CC: Minkyu Kang mk7.kang@samsung.com
board/samsung/goni/goni.c | 33 +++++++++++++++++++++++++++++++-- 1 file changed, 31 insertions(+), 2 deletions(-)
diff --git a/board/samsung/goni/goni.c b/board/samsung/goni/goni.c index 5b3d6ef..d63e902 100644 --- a/board/samsung/goni/goni.c +++ b/board/samsung/goni/goni.c @@ -72,7 +72,7 @@ int checkboard(void) #ifdef CONFIG_GENERIC_MMC int board_mmc_init(bd_t *bis) {
- int i;
int i, ret, ret_sd = 0;
/* MASSMEMORY_EN: XMSMDATA7: GPJ2[7] output high */ s5p_gpio_direction_output(&s5pc110_gpio->j2, 7, 1);
@@ -95,7 +95,36 @@ int board_mmc_init(bd_t *bis) s5p_gpio_set_drv(&s5pc110_gpio->g0, i, GPIO_DRV_4X); }
- return s5p_mmc_init(0, 4);
- ret = s5p_mmc_init(0, 4);
- if (ret)
puts("MMC: Failed to init MMC:0.\n");- /*
* SD card (T_FLASH) detect and init* T_FLASH_DETECT: EINT28: GPH3[4] input mode*/- s5p_gpio_cfg_pin(&s5pc110_gpio->h3, 4, GPIO_INPUT);
- s5p_gpio_set_pull(&s5pc110_gpio->h3, 4, GPIO_PULL_UP);
- if (!s5p_gpio_get_value(&s5pc110_gpio->h3, 4)) {
for (i = 0; i < 7; i++) {if (i == 2)continue;/* GPG2[0:6] special function 2 */s5p_gpio_cfg_pin(&s5pc110_gpio->g2, i, 0x2);/* GPG2[0:6] pull disable */s5p_gpio_set_pull(&s5pc110_gpio->g2, i, GPIO_PULL_NONE);/* GPG2[0:6] drv 4x */s5p_gpio_set_drv(&s5pc110_gpio->g2, i, GPIO_DRV_4X);}ret_sd = s5p_mmc_init(2, 4)if (ret_sd)puts("MMC: Failed to init SD card (MMC:2).\n");
I think you can refer to trats.c.
Best Regards, Jaehoon Chung
- }
- return ret | ret_sd;
} #endif