Hello Peter,
This patch set is a reworked patch which incorporates all review
feedbacks from
earlier earlier mails
This patch set contains the support for 4 SoCs SPEAr600 SPEAr300 SPEAr310 SPEAr320
SPEAr is an ARM based SoC which supports rich set of peripherals like
Ethernet,
USB Host, USB Device etc to support various generalapplications
For further info on SPEAr SoC, please see README.spear also contained
in the
patch set.
Vipin (9): Added README.spear SPEAr600 SoC support added SPEAr300 SoC support added SPEAr310 SoC support added SPEAr320 SoC support added i2c driver support for SPEAr SoCs smi driver support for SPEAr SoCs nand(fsmc) driver support for SPEAr SoCs usbd driver support for SPEAr SoCs
It would be nice if you reordered the patches. At a glance, some of the boards added first rely on drivers added later. Eg patch 1 uses the I2C driver in patch 6. This will cause 'git bisects' to break. To prevent this you should add SOC + driver code first, then boards last. Something like:
- Initial SPEAr SOC support
- SPEAr: Add I2C support
- SPEAr: Add SMI support
.... 6. Add SPEAr 600 board support 7. Add SPEAr 300 board support 8. Add SPEAr 310 board support 9. Add SPEAr 320 board support
I am planning to keep the patch order as it is but I would remove dependencies eg. SPEAr600 would not contain code that depends on a driver added later and so on.
This should also be OK. Right?
Regards, Vipin