When DSA_SANDBOX is not set, the sandbox tests fail as follows:
$ ./test/py/test.py --build-dir=$(pwd) -k bootdev_test_any [...] Test: bootdev_test_any: bootdev.c test/boot/bootdev.c:156, bootdev_test_any(): "mmc2" = media->name: Expected "mmc2", got "mmc0" [...]
This is due to the device list containing two less entries than expected. Therefore, adjust the expected index to be two less when DSA_SANDBOX is disabled.
The actual use case is NET_LWIP=y (to be introduced in later patches) which implies DSA_SANDBOX=n for the time being.
Signed-off-by: Jerome Forissier jerome.forissier@linaro.org --- test/boot/bootdev.c | 11 ++++++++++- 1 file changed, 10 insertions(+), 1 deletion(-)
diff --git a/test/boot/bootdev.c b/test/boot/bootdev.c index c635d06ec25..369105ca4cf 100644 --- a/test/boot/bootdev.c +++ b/test/boot/bootdev.c @@ -128,6 +128,7 @@ BOOTSTD_TEST(bootdev_test_labels, UTF_DM | UTF_SCAN_FDT | UTF_ETH_BOOTDEV); static int bootdev_test_any(struct unit_test_state *uts) { struct udevice *dev, *media; + char *seq; int mflags;
/* @@ -147,8 +148,16 @@ static int bootdev_test_any(struct unit_test_state *uts) * 8 [ ] OK mmc mmc2.bootdev * 9 [ + ] OK mmc mmc1.bootdev * a [ ] OK mmc mmc0.bootdev + * + * However if DSA_SANDBOX is disabled the dsa-test@{0,1} devices + * are not there. */ - ut_assertok(bootdev_find_by_any("8", &dev, &mflags)); + if (CONFIG_IS_ENABLED(DSA_SANDBOX)) + seq = "8"; + else + seq = "6"; + + ut_assertok(bootdev_find_by_any(seq, &dev, &mflags)); ut_asserteq(UCLASS_BOOTDEV, device_get_uclass_id(dev)); ut_asserteq(BOOTFLOW_METHF_SINGLE_DEV, mflags); media = dev_get_parent(dev);