Hi Siddharth,
Thank you for the patch.
On mer., déc. 18, 2024 at 18:15, Siddharth Vadapalli s-vadapalli@ti.com wrote:
Since USB DFU boot is supported on AM62Px SoC, document the steps required to build the image for USB DFU boot along with the steps to send images using the "dfu-util" tool.
Signed-off-by: Siddharth Vadapalli s-vadapalli@ti.com
Reviewed-by: Mattijs Korpershoek mkorpershoek@baylibre.com
This patch has been newly introduced in this series based on the discussion at: https://patchwork.ozlabs.org/project/uboot/patch/20241217131658.2920799-3-s-...
NOTE: This patch should only be merged if all other patches in this series will also be merged, in order to ensure that the feature is documented only if it is supported (i.e. all patches in this series which are required for the feature to be functional have been merged).
doc/board/ti/am62px_sk.rst | 31 +++++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+)
diff --git a/doc/board/ti/am62px_sk.rst b/doc/board/ti/am62px_sk.rst index 99bdc034869..75451ad76b5 100644 --- a/doc/board/ti/am62px_sk.rst +++ b/doc/board/ti/am62px_sk.rst @@ -124,6 +124,18 @@ Set the variables corresponding to this platform: :start-after: .. k3_rst_include_start_build_steps_spl_r5 :end-before: .. k3_rst_include_end_build_steps_spl_r5
+* 3.1.1 Alternative build of R5 for DFU boot:
- As the SPL size can exceed the limit when building it with support for
- booting from both local storage *and* DFU, in order to disable the
- configs not required for DFU boot, a config fragment should be used
- to not only enable configs for DFU boot, but also disabled the unneeded
- configs.
+.. prompt:: bash $
- export UBOOT_CFG_CORTEXR="${UBOOT_CFG_CORTEXR} am62x_r5_usbdfu.config"
- 3.2 A53:
.. include:: ../ti/k3.rst @@ -290,6 +302,25 @@ https://www.ti.com/lit/pdf/spruj83 under the `Boot Mode Pins` section.
For SW2 and SW1, the switch state in the "ON" position = 1.
+DFU based boot +--------------
+To boot the board over DFU, set the switches to DFU mode and connect to the +USB type C DRD port on the board. After power-on the build artifacts needs to be +uploaded one by one with a tool like dfu-util.
+The initial ROM will have a DFU alt named `bootloader` for the initial R5 spl +upload. The next stages as exposed by U-Boot have target alts matching the name +of the artifacts, for these a USB reset has to be done after each upload.
+When using dfu-util the following commands can be used to boot to a U-Boot shell:
+.. prompt:: bash $
- dfu-util -a bootloader -D tiboot3.bin
- dfu-util -R -a tispl -D tispl.bin
- dfu-util -R -a u-boot.img -D u-boot.img
Debugging U-Boot
-- 2.43.0