On 2/7/23 02:00, Tony Dinh wrote:
Currently, only the 1st SATA port is powered up (by GPIO1 12). Add GPIO1 13 in board initialization to power up the 2nd SATA port.
Note that this patch depends on the initial add-support patch: https://patchwork.ozlabs.org/project/uboot/patch/20230201231306.7010-1-mibod...
Signed-off-by: Tony Dinh mibodhi@gmail.com
Applied to u-boot-marvell/master
Thanks, Stefan
Changes in v2:
Use BIT macros to make it easier to see which GPIOs are used.
Resent to correct missing BIT(0) in N2350_GPP_OUT_VAL_MID
board/thecus/n2350/n2350.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/board/thecus/n2350/n2350.c b/board/thecus/n2350/n2350.c index 4cfdfba662..fd8f95f944 100644 --- a/board/thecus/n2350/n2350.c +++ b/board/thecus/n2350/n2350.c @@ -24,8 +24,8 @@ DECLARE_GLOBAL_DATA_PTR;
#define N2350_GPP_OUT_ENA_LOW (~(BIT(20) | BIT(21) | BIT(24))) #define N2350_GPP_OUT_ENA_MID (~(BIT(12) | BIT(13) | BIT(16) | BIT(19) | BIT(22))) -#define N2350_GPP_OUT_VAL_LOW 0x1200000 -#define N2350_GPP_OUT_VAL_MID 0x1001 +#define N2350_GPP_OUT_VAL_LOW (BIT(21) | BIT(24)) +#define N2350_GPP_OUT_VAL_MID (BIT(0) | BIT(12) | BIT(13)) #define N2350_GPP_POL_LOW 0x0 #define N2350_GPP_POL_MID 0x0
Viele Grüße, Stefan Roese