Hello,
thanks a lot.
Could you please take care that this will be fixed in the kernel code, too ?
Best regards
Manuel Sahm
Anatolij Gustschin schrieb:
Manuel Sahm wrote:
if I apply the patch with:
patch -p1 < patchat91.diff
some messages occur, is this correct ?
(Stripping trailing CRs from patch.) patching file board/atmel/at91sam9260ek/at91sam9260ek.c patch unexpectedly ends in middle of line Hunk #1 succeeded at 183 with fuzz 2 (offset -5 lines).
it is very likely that these messages occur because the patch was incorrectly saved from the email body. This patch applies cleanly against top of our u-boot git tree.
The description is correct - PA23 and PA24 are connected to the TWI EEPROM an the DevBoard at91sam9260ek. The patch works well. Here the signed-off line:
Signed-off-by: Manuel Sahm Manuel.Sahm@feig.de
Thanks, I will repost the patch again.
Another problem is, that the same error is in the official kernel tree in the file at91sam9260ek_devices.c ?! Although the error is still in the kernel, a modification of the uboot file at91sam9260ek.c is enough to get ethernet working ?
if the kernel resets Peripheral B pin configuration, then ethernet will stop working, I think. This should be fixed in the kernel code, too.
Best regards, Anatolij