10 May
2006
10 May
'06
12:13 a.m.
In message 200605092249.11586.antonio.dibacco@aruba.it you wrote:
I have 16MB of RAM (0x01000000) then I specified BR2=0x0000xxxx and OR2=0xFE000000 . Obviously if I write at 1000000 is the same as I write at 0x00000000. That is, the memory repeats in the space address. This doesn't seem good to me because I will not receive any bus error if go to an address higher than my RAM size. Am I wrong?
Why do you set OR2 to this value then, after you know it is wrong?
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
Live long and prosper.
-- Spock, "Amok Time", stardate 3372.7