13 Sep
2012
13 Sep
'12
9:48 a.m.
Am 13/09/2012 06:55, schrieb Fabio Estevam:
Hi Stefano,
On Wed, Sep 12, 2012 at 6:44 PM, stefano babic sbabic@denx.de wrote:
U-Boot for mx35pdk runs from NOR and not from NAND. There is no support to run from NAND. Even if I can "convince" the board to boot from NAND, this was not pushed to mainline. I explain why.
Reading board/freescale/mx35pdk/README it gives the impression that booting from NAND is supported.
It is a wrong impression, it is not (yet) supported..
Should this be updated?
Yes !
Regards, Stefano
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de
=====================================================================