Hello :-)
I would like to create a standalone application and I already read manual and also asked help here and got one good example however I can't get It working and I think the problem is in the address.
I am using an Olimex dev. board with a ARM9, AT91SAM9260 MCU. On my makefile I am linking with address 0xc100000, "LDFLAGS=-Bstatic -Ttext 0xc100000" -- is this address correct? How can I have sure of that? -- I got this value from makefile of "hello world" example.
When I do "tftp 0xc100000 flash_led.bin" the system hangs.. while If I try to do for example "tftp 0x1000 flash_led.bin" the code loads ok but after "go 0x1000", the code does not work... It evens return while shouldn't because of an infinite loop on the code.
In the manual of the dev. board I have a memory map that says the 64MB RAM starts at 0x20000000 and ends on 0x23FFFFFF - If I do "tftp 0x20000000 flash_LED.bin" system also hangs...
Can someone help me?
My flash_LED code is here: http://code.google.com/p/rockboxplayer/source/browse/trunk/flash_LED
And the help, example, I got before here in the mailing list: http://code.google.com/p/rockboxplayer/wiki/Flash_LED
I must say that with my dev. board comes an "hello world" example which is an empty function :-( -- but even I don't know to what address I should load it.
I did turn ON and OFF the LED on the dev. board using U-Boot shell, using the memory write and memory display commands ;-) -- I did write configure values to the PIO controller, enabling the PA6 pin as output and set and clear that pin to turn OFF and ON the green LED.
I am working on a Free/Open hardware digital audio player and recorder: http://www.rockbox.org/twiki/bin/view/Main/RockboxPlayer
Thanks in advance,
JPCasainho - http://www.Casainho.net