Re: ZynqMP boot: no messages from SPL other than "Debug uart enabled"

Hi,

On 28. 04. 20 12:53, Major A wrote:

Hi Michal,

Xilinx doesn't like me.  Here's the output and where I get stuck:

xsdb% targets -set -filter {name =~ "PSU"} no targets found with "name =~ "PSU"". available targets:   1  whole scan chain (DR shift through all zeroes) xsdb%

Any ideas?  Any jumpers I failed to set?  Boot mode is set to JTAG.

check jtag ta - that you see the board. Reset the board, check that jtag mode pins again.

Thanks, Michal