Dear Sir/Madam,
Hello,
We have developed an i.mx6dl board which is based on "MX6 Dual Lite SABRE AI CPU2 Card with AVB". I am using version u-boot-2018.01 with SPL. I am downloading SPL and u-boot.img with USB loader; downloaded kernel and device tree files and run them in nfs tftp search over ethernet..
Then I programmed the SPI NOR flash with u-boot with spi read/write commands for both u-boot.imx/and u-boot.img images with offset value of 0x400 in Flash address, set boot pins accordingly, saw signals at clock, CS and Data pins of flash after reset, but never see a boot (character at terminal) for last few weeks.
As I know, make command is generating code for SD card, and SPL code is waiting u-boot to be loaded from USB port. I searched many NXP/denx forums; i.mx6 linux kernel ref. Manuals for u-boot with SPL, I found NXP supports u-boot.imx images, but did not support SPL+u-boot.img.
So I would be very grateful, if any of you know which (and how) files, parameters (and/or make command) should be set for u-boot.img+SPL boot for SPI nor flash boot in u-boot 2018.1? Or give link to document(s), which explain the i.mx6dl SPL and u-boot.img boot process for SPI nor flash (except i.mx6 ref manual)..
Thanks and best regards.
Mehmet Ali Ipin