Hi Patrice,
On 5/12/22 09:17, Patrice Chotard wrote:
Currently, SR_TCF flag is checked in case there is data, this criteria is not correct.
SR_TCF flags is set when programmed number of bytes have been transferred to the memory device ("bytes" comprised command and data send to the SPI device). So even if there is no data, we must check SR_TCF flag.
Signed-off-by: Patrice Chotard patrice.chotard@foss.st.com
drivers/spi/stm32_qspi.c | 23 +++++++++++------------ 1 file changed, 11 insertions(+), 12 deletions(-)
diff --git a/drivers/spi/stm32_qspi.c b/drivers/spi/stm32_qspi.c index 8f4aabc3d1..3c8faecb54 100644 --- a/drivers/spi/stm32_qspi.c +++ b/drivers/spi/stm32_qspi.c @@ -150,20 +150,19 @@ static int _stm32_qspi_wait_cmd(struct stm32_qspi_priv *priv, u32 sr; int ret = 0;
- if (op->data.nbytes) {
ret = readl_poll_timeout(&priv->regs->sr, sr,sr & STM32_QSPI_SR_TCF,STM32_QSPI_CMD_TIMEOUT_US);if (ret) {log_err("cmd timeout (stat:%#x)\n", sr);} else if (readl(&priv->regs->sr) & STM32_QSPI_SR_TEF) {log_err("transfer error (stat:%#x)\n", sr);ret = -EIO;}/* clear flags */writel(STM32_QSPI_FCR_CTCF | STM32_QSPI_FCR_CTEF, &priv->regs->fcr);
ret = readl_poll_timeout(&priv->regs->sr, sr,
sr & STM32_QSPI_SR_TCF,STM32_QSPI_CMD_TIMEOUT_US);if (ret) {
log_err("cmd timeout (stat:%#x)\n", sr);} else if (readl(&priv->regs->sr) & STM32_QSPI_SR_TEF) {
log_err("transfer error (stat:%#x)\n", sr);ret = -EIO;}
/* clear flags */
writel(STM32_QSPI_FCR_CTCF | STM32_QSPI_FCR_CTEF, &priv->regs->fcr);
if (!ret) ret = _stm32_qspi_wait_for_not_busy(priv);
Reviewed-by: Patrick Delaunay patrick.delaunay@foss.st.com
Thanks Patrick