Dear Stefano Babic,
- should CONFIG_SKIP_RELOCATE_UBOOT be not defined anymore?
I had the same issue because I forget to remove it from my config file. After dropping it, I got the u-boot prompt again ;-)
Thank you, that (partially) helped:
U-Boot 2010.09-00106-g6e135b9-dirty (Sep 30 2010 - 17:32:36)
U-Boot code: 21F00000 -> 21F3C180 BSS: -> 21F7D700 CPU: AT91SAM9XE Crystal frequency: 18.432 MHz CPU clock : 198.656 MHz Master clock : 99.328 MHz I2C: ready monitor len: 0007D700 ramsize: 04000000 Top of RAM usable for U-Boot at: 24000000 Reserving 501k for U-Boot at: 23f82000 Reserving 143k for malloc() at: 23f5e100 Reserving 24 Bytes for Board Info at: 23f5e0e8 Reserving 88 Bytes for Global Data at: 23f5e090 New Stack Pointer is: 23f5e088 RAM Configuration: Bank #0: 20000000 64 MiB relocation Offset is: 02082000 monitor flash len: 0003C180 Now running in RAM - U-Boot at: 23f82000 FLASH: 512 KiB NAND: raise: Signal # 8 caught raise: Signal # 8 caught raise: Signal # 8 caught 256 MiB *** Warning - bad CRC, using default environment
In: serial Out: serial Err: serial MMC: mci: 0 Net: macb0, enc1.0, enc1.1, enc1.2 Reset Ethernet PHY macb0: Starting autonegotiation... macb0: Autonegotiation timed out (status=0x7849) macb0: link down (status: 0x7849) enc1.0: timeout waiting for CLKRDY enc1.1: timeout waiting for CLKRDY enc1.2: timeout waiting for CLKRDY Press SPACE to abort autoboot in 1 seconds
Before the relocation: macb, enc and environment did work :) I have to look into that issue later...
Best Regards, Reinhard