For some reason code setting the speed based on the PHY feedback causes troubles on AM3517 so hardcode 100Mbps for now.
Signed-off-by: Ilya Yanok yanok@emcraft.com --- drivers/net/davinci_emac.c | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c index 4318a39..a35ebeb 100644 --- a/drivers/net/davinci_emac.c +++ b/drivers/net/davinci_emac.c @@ -461,7 +461,8 @@ static int davinci_eth_open(struct eth_device *dev, bd_t *bis) writel(1, &adap_emac->RXUNICASTSET);
/* Enable MII interface and Full duplex mode */ -#ifdef CONFIG_SOC_DA8XX +#if defined(CONFIG_SOC_DA8XX) || \ + (defined(CONFIG_OMAP34XX) && defined(CONFIG_DRIVER_TI_EMAC_USE_RMII)) writel((EMAC_MACCONTROL_MIIEN_ENABLE | EMAC_MACCONTROL_FULLDUPLEX_ENABLE | EMAC_MACCONTROL_RMIISPEED_100),