Re: [PATCH 10/13] imx: load calibration parameters from fuse for i.MX8MP

Hi Peng and Ye Li,

On Sun, May 3, 2020 at 10:57 AM Peng Fan peng.fan@nxp.com wrote:

From: Ye Li ye.li@nxp.com

i.MX8MP thermal which has two probes and supports temperature range from -40 to 125. The driver still uses default 1p HW calibration at 25C and loads calibration parameters from fuse.

Reviewed-by: Peng Fan peng.fan@nxp.com Signed-off-by: Ye Li ye.li@nxp.com Signed-off-by: Peng Fan peng.fan@nxp.com

Are you able to boot an NXP 5.4.3 kernel on a i.MX8MP EVK board?

I am getting a kernel hang right after the serial console is probed: https://pastebin.com/3AtvJqWS

Any suggestions?

I am using ATF from 5.4.3, firmware version is 8.6 and I pass 'export ATF_LOAD_ADDR=0x960000'.

Any ideas?

Thanks