On Thursday, September 03, 2015 at 08:44:00 PM, Moritz Fischer wrote:
Hi all,
Hi!
this patch adds basic support for NI Ettus Research E3XX series boards. I tagged this RFC because I'm not sure if the boards/xilinx/zynq subdirectory is the correct place for this, as I'll have some follow up patches that read the devices EEPROM for ethernet address etc.
It's not, it should be board/ettus/e3xx/ .
Would putting it under boards/ni/zynq be the correct way of integrating it? While technically a Zynq device there are a lot of custom modifications, that I wouldn't like to force into board/xilinx/zynq/board.c in my follow up patches. However duplicating the entire board.c doesn't seem like a good idea neither.
Any suggestions? For future reference do you want me to split out dts etc in a separate patch?
It's always boards/VENDOR/BOARD/ .
Best regards, Marek Vasut