Hello,
as mentioned before i´m using two Marvel 88E1111 PHY on my PPC440GX Board. They are configured as a RGMII to copper interface for use with EMAC 2 & 3. So now i´m in trouble with the configuration of the network. After booting i set with "setenv ethact ppc_440x_eth2" EMAC2 for networking. After that i try a "ping" to know if network is working. Reading the speed and duplex from PHY works, but after that i got in an endless loop. I figured out, that no interrupt is recognized and in 440gx_enet.c in ppc_440x_eth_init the default configuration of the interrupt handler is for ETH0:
irq_install_handler (VECNUM_EWU0 + (hw_p->devnum * 2), (interrupt_handler_t *) enetInt, dev); irq_install_handler (VECNUM_ETH0 + (hw_p->devnum * 2), (interrupt_handler_t *) enetInt, dev);
so i changed it as following...
irq_install_handler (VECNUM_EWU2 + (hw_p->devnum * 2), (interrupt_handler_t *) enetInt, dev); irq_install_handler (VECNUM_ETH2 + (hw_p->devnum * 2), (interrupt_handler_t *) enetInt, dev);
and added in vecnum.h these lines:
#define VECNUM_ETH2 (64 + 0) /* Ethernet 0 interrupt status */ #define VECNUM_EWU2 (64 + 1) /* Ethernet 0 wakeup */
But this didn´t solve the problem. Actually i also couldn´t get the TxCLK work on my RGMII Bridge and i don´t know why. The devices are configured as 100 MBit RGMII and receiving packets from network seems to be functioning (EMAC_OCRX Register increments rapidly). I would be appreciated if someone could give me a tip, what i have forgot to do.
Greets,
David