2 Dec
2003
2 Dec
'03
9:13 p.m.
In message 200312021130.26182.acurtis@onz.com you wrote:
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
Well, this is a setting which is definitely hardware (board) depen- dend. So if you don't give away any facts about your hardware it is impossible to help (actually it's probably impossible in general as this might be a custom board).
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd@denx.de
Every program has at least one bug and can be shortened by at least
one instruction - from which, by induction, one can deduce that every
program can be reduced to one instruction which doesn't work.