Hi,
I am using windoze kermit. So, I would type loadb first. Then, click on kermit->send. Am I doing something wrong here? Are there options needed by u-boot to successfully communicate/download files with kermit, i.e. protocol?
Thanks, Rodel
P.S. Doesnt the fact that I could type commands successfully means my UART is working and downloading binaries on the same UART port using loadb would be just as easy as clicking the send option in kermit?
On Fri, 19 Nov 2004 16:25:14 +0100, Wolfgang Denk wd@denx.de wrote:
In message 698a2fda04111900596ef08084@mail.gmail.com you wrote:
some commands successfully, e.g. go, printenv, help, etc. However, when I try to download a binary image using kermit's send, and typing loadb to the serial console, the message "Remote Kermit Not
This sounds as if you were trying to do it in the wrong order. You are aware that you FIRST start "loadb", then disconnent, and only then type "send /bin ...filename..." at the kermit pro,mpt?
Responding" is logged on the terminal. When I type ^C, the message states that I have downloaded 0 bytes. What could be causing this problem? What U-Boot configuration might I have missed out? What
This is most likely a usage error. See the manual for instructions how to configure Kermit.
Best regards,
Wolfgang Denk
-- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de The explanation requiring the fewest assumptions is the most likely to be correct. -- William of Occam