Hi Simon,
On Mon, Jun 19, 2017 at 11:11:31AM -0600, Simon Glass wrote:
Move this board over to driver model for MMC and SATA. This means that it uses CONFIG_BLK as well. In SPL these options remain turned off since it increases the code size. One option would be to use CONFIG_SPL_OF_PLATDATA to avoid device-tree overhead.
Signed-off-by: Simon Glass sjg@chromium.org
arch/arm/dts/sun7i-a20-pcduino3.dts | 1 - configs/Linksprite_pcDuino3_defconfig | 7 ++++++- 2 files changed, 6 insertions(+), 2 deletions(-)
diff --git a/arch/arm/dts/sun7i-a20-pcduino3.dts b/arch/arm/dts/sun7i-a20-pcduino3.dts index 1a8b39be1d..d487c84562 100644 --- a/arch/arm/dts/sun7i-a20-pcduino3.dts +++ b/arch/arm/dts/sun7i-a20-pcduino3.dts @@ -164,7 +164,6 @@ pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>; vmmc-supply = <®_vcc3v3>; bus-width = <4>;
- cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */
Why is this change needed ? Is that the wrong GPIO? Should that be submitted to Linux too?
Thanks! Maxime