Hi Fabio,
On Thu, Oct 08, 2015 at 01:24:19PM -0300, Fabio Estevam wrote:
Hi Peng,
On a mx6qp sabreauto I noticed that the board hangs after doing:
=> saveenv => reset
U-Boot 2015.10-rc4-24385-ge04e21c-dirty (Oct 08 2015 - 13:08:54 -0300)
CPU: Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz) CPU: Automotive temperature grade (-40C to 125C) at 38C Reset cause: POR Board: MX6Q-Sabreauto revA I2C: ready DRAM: 2 GiB PMIC: PFUZE100 ID=0x10 Flash: 32 MiB NAND:
(hangs here)
Any ideas?
Thanks
Whether plugging nand chip into the socket or without nand chip, the board reboot well in my side. I did not do stress test, only do a few test, and each time 'reset', it can boot fine.
" => saveenv Saving Environment to MMC... Writing to MMC(0)... done => reset resetting ...
U-Boot 2015.10-rc4-00050-g996ec1d (Oct 09 2015 - 10:09:19 +0800)
CPU: Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz) CPU: Automotive temperature grade (-40C to 125C) at 38C Reset cause: WDOG Board: MX6Q-Sabreauto revA I2C: ready DRAM: 2 GiB PMIC: PFUZE100 ID=0x10 Flash: 32 MiB NAND: 0 MiB MMC: FSL_SDHC: 0 No panel detected: default to HDMI Display: HDMI (1024x768) In: serial Out: serial Err: serial Net: , FEC [PRIME] Warning: FEC using MAC address from net device
Hit any key to stop autoboot: 0 "
Regards, Peng.
--