On 2011/03/18 12:53 PM, Prafulla Wadaskar wrote:
-----Original Message----- From: u-boot-bounces@lists.denx.de [mailto:u-boot-bounces@lists.denx.de] On Behalf Of rogan@dawes.za.net Sent: Friday, March 18, 2011 1:40 PM To: u-boot@lists.denx.de Subject: [U-Boot] Non-working Relocated DNS323 config
This patch series contains the previous working configuration for the DNS323, forward-ported to mainline, taking into account changes made to the EDMiniV2 configuration on which this is based.
Unfortunately, this does not boot at all. I get:
Marvell>> bootm ## Booting image at 00100000 ... Image Name: UBoot dns323 Image Type: ARM U-Boot Kernel Image (uncompressed) Data Size: 170100 Bytes = 166.1 kB Load Address: 03000000 Entry Point: 03000000 Verifying Checksum ... OK OK
Starting kernel ...
There might be machine id mismatch in the kernel and programmed in u-boot for this board.
Regards.. Prafulla . .
Hi Prafulla,
That log is of me trying to chain load the new U-Boot from the vendor U-Boot. I am not yet ready to try flashing images, because my JTAG adapter has not yet arrived and been proved working :-)
What I was expecting to see after the "Starting kernel ..." was the new U-Boot starting up. Instead, it simply hung.
The "working config" gives me:
Starting kernel ...
U-Boot 2010.06 (Mar 18 2011 - 13:24:33) DNS323B1
SoC: Orion5x MV88F5182-A2 DRAM: 64 MiB Flash: 8 MiB *** Warning - bad CRC, using default environment
In: serial Out: serial Err: serial Net: egiga0 88E1116 Initialized on egiga0 DNS323B1>
The non-working one just hangs.
Regards,
Rogan